32
• Icon: Displays the icon used to represent the unit.
Note: If a transmitter’s streams require more bandwidth than is available, a warning icon ( ) will be
displayed instead of the normal source icon. Video output from a source displaying this icon may
become visually unstable. It is recommended to either lower the resolution or framerate of the stream.
• Order: Use the dropdown to reorder the units in the list. Changing the order here will
also change the order the units are listed in other tabs.
• Name: Displays each unit’s current assigned name.
• Note: The name can be changed within “Device Settings”.
• IP Address: Displays each unit’s current IP address.
• Video Info: Clicking this button will display a pop-up window containing detailed
information about the current video source.
Note: If no live source is detected the button will turn red.
• Network Settings: Clicking this button will display a pop-up window containing
detailed information about the unit’s current network settings, including IP mode,
and allow for those settings to be changed. To activate any changes made, please
click on the “Save” button to close the window.
• RS-232 Settings: Clicking this button will display a pop-up window containing
detailed information about the unit’s current RS-232 settings, including baud rate,
and allow for those settings to be changed. To activate any changes made, please
click on the “Save” button to close the window.
• Device Settings: Provides controls over a number of unit-specific functions. See
below for more detail.
• USB Settings: Clicking this button will display a pop-up window containing detailed
information about the unit’s current USB settings, including enabling or disabling
simultaneous mode support. To activate any changes made, please click on the
“Save” button to close the window.
Note: USB functionality is not supported by all SDVoE units.
2. Device Settings: Clicking this button will display a pop-up window providing control over a
number of important device settings and allow for those settings to be changed. To activate
any changes made, please click on the “Save” button to close the window.
• Version: Display the unit’s current firmware version.
To Next Page
Loading...
