111
The long (JHEARD L) version of this command will also show the destination field and
any digipeaters used.
Nodes [Short|Long]
Causes the node to return a list of KA-Nodes it has heard, as well as K-Net, G8BPQ,
NET/ROM and TheNet nodes. The format of the list is similar to that of the JHEARD list
above.
Xconnect callsign
Note: The Xconnect callsign command is available only in KA-nodes in Kantronics‘
multi-port TNCs.
Causes the node to issue a connect request to ―callsign‖ (in the usual AX.25 format) on
the opposite port of the KA-Node. Cross connecting enables you to gain access, via the
node, to another frequency.
To Next Page
Loading...
