199
Entering LONG will cause the TNC to display the status of all streams allowed by
MAXUSERS, PBBS, NUMNODES, and MYREMOTE.
The current KA-NODE input and output (IO) stream is also indicated. A pound sign ‗#‘
(octothorpe) indicates that there is unacknowledged data in the buffers for that stream.
The number immediately following the # is the number of bytes outstanding. The
number in parentheses is the number of packets not yet acknowledged.
The following is an example of a display (using STATUS LONG). A, B, C, through J
(i.e., MAXUSERS = 10) indicate the stream. ―A‖ stream is connected to KEØSM and
has 50 bytes in 2 packets that are unacknowledged. The current stream (IO) is the ―B‖
stream, which is connected to NØKN. KBØNYK is connected on circuit ―A‖ of the KA-
Node. All other streams, node circuits, the BBS, and the remote access are
disconnected. Appending ―/P‖ to the callsign indicates that the connection is permanent
(see CONPERM).
cmd: status long
FREE BYTES 1661
A stream - #50(2) CONNECTED to KEØSM
B stream - IO CONNECTED to NØKN/P
C stream - DISCONNECTED
J stream - DISCONNECTED
BBS DISCONNECTED
REM DISCONNECTED
Ain CONNECTED to KBØNYK
Aout DISCONNECTED
Bin DISCONNECTED
Bout DISCONNECTED
See also: conperm, maxusers, myremote, numnodes, pbbs, streamsw
STOP n (n = $00 - $FF)
default $13 <Ctrl+S>
This command specifies the character sent by the computer to the TNC to stop output
from the TNC. If set to $00 only hardware flow control will be used. For software flow
control set this parameter to the character the computer will send to stop data flow.
See also: start, xflow, xoff, xon
STREAMCA {ON | OFF}
default OFF
When receiving packets addressed only to you (MONITOR OFF and/or MCON OFF),
setting this command ON will enable the display of the callsign of the connected-to
To Next Page
Loading...
