Kantronics KPC-3 Plus - Page 45

236 pages

Save Page as PDF

To Next Page

To Previous Page

These diagrams may also apply to transceivers from other manufacturers, but you

need to check to be sure how your transceiver needs to be wired. See the section on

―Interfacing Hand-Held Radios‖ in the ―Advanced Installation‖ appendix for further

information.

Main Page

Contact Us2
Revisions3
Warranty Registration4
License Agreement5
- Table of Contents7
Limited Warranty9
- Return/Repair Procedures12
- Radio Frequency Interference Statement14
- RFI Suppression15
- FCC Declaration of Conformity16
Introduction17
- Welcome17
- Overview of this "User's Guide" Manual17
- Major Uses of Your KPC-3 Plus17
- Package Contents18
- Additional Parts for Your Packet Radio Station18
- Our Assumptions about You19
- Documentation Conventions19
- Overview of Packet Radio19
- Inside a TNC - the KPC-3 Plus27
Installing Your KPC-3 Plus29
- The Major Components of Your Station30
- Back Panel30
- How the Parts of Your Station Are Connected33
- Connect Your KPC-3 Plus to a Power Source34
- Connect Your KPC-3 Plus to Your Computer36
- Configure Your KPC-3 Plus39
- Connect the KPC-3 Plus to a Transceiver43
- Connecting to a GPS Device (Optional)53
Getting Started54
- The Front Panel of the KPC-3 Plus55
- Beginning a Packet Session55
- Giving Commands and Transmitting Data56
- NEWUSER Commands57
- Using NEWUSER Commands59
- Connect to Your Mailbox60
- Monitor Communications from Nearby Stations61
- Communicate Directly with a Nearby Station62
Modes of Operation64
- Packet Mode of Operation64
- Remote Access to Your TNC74
PBBS (Personal Mailbox)76
GPS NMEA Interfacing91
- GPS Operations95
KA-Node104
Introduction to Basic Packet Networking112
K-Net Network Node114
- K-Net Node Commands115
- WEFAX Mode137
- Other Modes of Operation139
- Modem Mode140
- Kantronics Host Mode Operation141
- KISS Mode142
Command Reference146
- Introduction146
Commands151
Appendix A: Advanced Installation209
- Precautions209
- Cable Wiring209
- Connecting to the Computer (DSUB-25)209
- Connecting to Your Radios212
Appendix B: Advanced Information215
- Assembly and Disassembly215
- Hard Reset215
- Calibration/Equalization216
- PTT (Push-To-Talk) Watchdog Timer217
- Microprocessor Watchdog Timer217
- A/D Converter217
- KPC-3 Plus Jumpers218
Appendix C: Options for the KPC-3 Plus221
- Low Power Operation221
- Expanding the RAM in the KPC-3 Plus221
- Installing the Optional Real-Time Clock Module221
- Replacing the Lithium Battery222
Appendix D: in Case of Difficulty223
- KPC-3 Plus Does Not "Sign-On" to Computer223
- You Are Unable to Make a "Connect223
  - Cannot Transmit223
  - Cannot Return to Command Mode224
Appendix E: Additional Information225
- Specifications225
- Messages from the KPC-3 Plus226
- ASCII Chart232
- KPC-3 Plus Parts List233
- KPC-3 Plus MX Parts List234
- KPC-3 Plus Parts Layout235
- KPC-3 Plus MX Parts Layout236

Kantronics KPC-3 Plus - Page 45

Table of Contents

Related product manuals