26
FT10 Start-up State
The telephone set would be ready for operation after the required connections have
been made and the correct extension number has been defined. The display and the
programmable keys start to perform their functions.
Beginning LED simulation will light just in yellow for the FT20 feature phones.
By default, there is no program assignment for the programmable keys. These keys are
to be programmed by user according to needs. Please refer to the section “Key
Settings and Automatic Settings” in this guide for detailed information. In order to
change settings of your telephone and other settings of your exchange, refer to the
section “Phone Settings”. Settings of telephone set are not cleared as the exchange is
shut down and then powered.
If the telephone set has previously been connected to the system and if it is connected
again after having been removed, then it gets ready for use within a few seconds. In
that short period, first the version information of FT10, then the “Terminal No:aa”
message appear on the display. After that message the telephone would be ready for
utilization.
In the event that the exchange is reset or is shut down and restarted while the
telephone has been connected to the exchange, the telephone first waits for the system
to start and display the version information of FT10 and then the message “Terminal
No: aa" (for 15 sec.), then it establishes the connection with the exchange after that
waiting period.
To Next Page
Loading...
