48
line that has not been defined in the system is entered, the message “Enter correct
number” is displayed.
A line access code can be assigned to a single key only.
After the programming mode has been exited, upon pressing those keys, it is possible
to access the programmed line, without pressing 9. While a line that has been assigned
to a programmable key has already been accessed, if that key is pressed, then the line
is parked. The line is retrieved upon pressing the key again.
WARNING
[FT20]Under the “Line” submenu, the access codes of ISDN (BRI/PRI) can not be
accepted.
[FT20] If the external line is called, this external line number will be displayed on the
screen continuously.
Status of the line, which has been programmed as the first function of the key can be
viewed by the LED next to it, as described below.
Line Status Red LED
Vacant Off
Busy Continuously On
Call request is being received Blinking
Parked Blinking fast
[FT20] Out of Service
Off
Private Pool Programming
You can program 20 line numbers for FT10 and 9 line numbers for FT20, which you call
most frequently on the private pool of your telephone. You could shorten duration of
calling action by programming the memory numbers on the keys. However, that
programming is carried out for FT20 depending on the memory storage that has been
done previously through the PHONE SETTINGS >PRIVATE POOL menu. On the other
hand, it can be used for FT10 for two kinds of programming. The first of them is a kind
of memory storage, in which 01-20 entries can be stored and determined numbers are
entered by the “no=” option. In the second of them, the entire programming codes out
of the service options that have been specified in the user’s guide can be assigned to
the programmable keys by entering the Feature codes.
FT10
♦ Press Key: The key, on which the programming will be done, is pressed for a
short or a long period in order to select the first or the second function,
respectively.
♦ Register no: Afterwards, the “Register no=” menu is displayed. In this menu, the
display cursor enables data entry. As soon as the user enters the second digit of
the number s/he has started to enter (01-20), FT10 automatically confirms the
number and checks whether the memory number that has already been entered
has previously been assigned to any key (this system is like the one in the
extension programming.)
♦ No: The desired line number or access code is entered. In order to assign the
service codes, on the other hand, first of all one of the codes that are mentioned in
To Next Page
Loading...
