55
Private Pool Entry (FT20)
♦ Register no: The private pool index in the range 1-9 is entered corresponding to
the “Register no” message displayed when this menu item is selected.
♦ No: Then, line number that will be assigned to the specified index is entered. No
code should be appended to the beginning of that number for accessing a line.
The STD, the ISD, or the GSM operator codes should be fully entered, including 0.
Extension numbers may not be assigned as private pool numbers.
Language
Any desired one out of the language options that are displayed here, such as Turkish,
English, Spanish, Afrikaans, Polish (FT20), Portuguese (FT10), Russian, French and
Greek can be selected and the telephone starts to display menu messages in the
selected language.
Headphone
The “Headset” option, which is presented in order to make use of the telephone
comfortably by a headset, offers three different options as disable, with handsfree and
without handsfree.
♦ Disable mode is already active when the “headset” option is selected for the first
time. It is employed for canceling the different later options.
♦ When With handsfree is selected, the telephone is picked up through the headset
while it is on hook, by the fast handsfree key. Upon pressing it again, the headset
is turned off and the telephone gets into the HF mode.
♦ When Without handsfree is selected, the telephone is not picked up through the
headset while it is on hook, by the fast handsfree key. If the handset is lifted during
a conversation via the headset, the voice level decreases, for it will be split into
two.
Signal Beep Option
♦ When the Enable option is selected, a special warning tone is received for an
incoming call, in case the phone is busy.
♦ The warning tone is cancelled through the Disable option.
In order to reach the “Enable” and “Disable” options, the “Accept” or “Select” options
may have to be employed more than once.
Price (FT20)
♦ By the Last Call selection, pricing of the last line, over which the call has been
made is done.
♦
Meter Pulse Price: By selecting “Accept” in this menu, upon entering the pricing
data of maximum five digits, which is considered to correspond to one pulse price,
To Next Page
Loading...
