46
o With Handsfree
o Without Handsfree
• Signal Beep Option (FT20)
o Enable/ Disable
• Price
o Last Call
o Meter Pulse Price
• Home Area Code
• Line Access Code
Key Settings
Number of keys that can be programmed is 16 in total and assignments of programs
are done to those. In case the user presses those keys continuously for one second,
the second function of the key is detected. Therefore, total number of features that can
be programmed becomes 32. During programming, the LED that belongs to the keys
signifies to which key and to which function of the key the assignment is done by
lighting in two colors. When the LED is observed to be lighting in green by pressing the
key until the single short beep is received, the first function will have been assigned
and the second function will have been assigned when the LED is observed to be
lighting in red by pressing the key until the short beep is received for the second time
(for 1 second.) The keys become active after the programming mode is exited
The assignments performed on these keys cannot be cancelled one by one; however,
new assignments can be done to them without encountering the error signal.
Cancellation of contents of the programmable keys can be carried out by selecting
Phone Settings > Key Settings > Auto Setting> Clear All.
Extension Programming
You can reach an extension you call frequently through a single key by programming
her/his number on that key. In order to do that, one first proceeds to the programming
menu.
♦ Press Key: The key, on which the programming will be done, is pressed for a
short or a long period in order to select the first or the second function,
respectively.
♦ Extension no: Then the “Extension No=”menu comes to view. In this menu, the
display cursor enables data entry. After the user enters the extension number by
using the numeric keypad, s/he confirms the extension number s/he has entered
by pressing the “Accept” key. The extension number is of 3 digits for FT10 and of 4
digits for FT20. In case an FT10 user attempts to enter an extension number with
more than 3 digits, the program takes the first three digits as the extension number
and then proceeds to the next menu. An FT20 user can enter an extension number
with at most 8 digits, in the event that s/he enters an incorrect number, the
program displays the “Erroneous Number” message.
After the acceptance of the extension number, FT checks whether the extension
number, which is desired to be programmed, has been set to any key before and if that
extension number has previously been programmed on any key, then the [Previously
Programmed (05)] message is displayed for 1 second and error tone is emitted. If, on
To Next Page
Loading...
