Kawai MP11 - Reverb Parameters; EFX Parameters

40
EDIT Menu
EDIT Menu parameters (PIANO, E.PIANO, SUB)
1 Reverb
1. Type
This parameter selects the reverb type.
* For more information about reverb, please refer to page 22.
* This parameter is common for all three sound sections.
* This parameter is not stored to SOUND but to SETUP only.
2. Pre Delay
This parameter adjusts the delay time before the start of the
reverberation.
* For more information about reverb, please refer to page 22.
* This parameter is common for all three sound sections.
* This parameter is not stored to SOUND but to SETUP only.
3. Time
This parameter adjusts the reverb time.
* For more information about reverb, please refer to page 22.
* This parameter is common for all three sound sections.
* This parameter is not stored to SOUND but to SETUP only.
4. Depth
This parameter adjusts the reverb depth.
* For more information about reverb, please refer to page 22.
2 .1 EFX
1. Category
This parameter selects the eect category.
* For more information about eects, please refer to page 23.
* The E.PIANO section lists two pages for EFX1 and EFX2.
2. Type
This parameter selects the eect type.
* For more information about eects, please refer to page 23.
* The E.PIANO section lists two pages for EFX1 and EFX2.
3. Parameters
These parameters change depending on the selected EFX type,
and are used to adjust the mixing amount of the eected (wet)
and bypassed (dry) sound, depth, speed, feedback, etc.
* For more information about eects, please refer to page 23.
value: 0 ~ 200 ms
value: 0 ~ 127value: 300 ms ~ 10.0 s
6 types
23 categories 129 types
n/a
MP11_EN_20140421_R102.indd 40 2014/04/22 8:48:54