Kawai MP6 - Page 29

29
5. Control Knobs
19. ROTARY 2 slow/fast - drive
20. AUTO WAH sense 0 -127 dry/wet
21. PEDAL WAH sense 0 -127 dry/wet
22. ENHANCER intensity 0 -127 wet level
23. OVERDRIVE drive 0 -127 dry/wet
REVERB parameter list
REVERB Time REVERB Depth
1. HALL 1 rev.time 0.3 - 8.0s send level
2. HALL 2 rev.time 0.3 - 8.0s send level
3. STAGE 1 rev.time 0.3 - 5.0s send level
4. STAGE 2 rev.time 0.3 - 5.0s send level
5. ROOM 1 rev.time 0.3 - 3.0s send level
6. ROOM 2 rev.time 0.3 - 3.0s send level
7. PLATE rev.time 0.3 - 3.0s send level
Note:
When EFX/REVERB depth is set to 0 while the EFX/REVERB button is active, the
EFX/REVERB button will blink to indicate that the EFX/REVERB is turned ON but
the depth is set to 0.
EFX rate and REVERB time are eective to internal zone only.
If the selected zone is set to BOTH, changing the value for EFX depth or REVERB
depth aects for both internal and external sections. If you want dierent settings
for internal and external sections, rst enter the edit mode by pressing the MENU
button and press the EFFECT button. Now you can select internal or external zone
with ZONE SELECT button. (See page 35 for details.)
Quick Change Reverb Oset
Press and hold the EFFECT button. The EFFECT button starts blinking and the
following screen for Reverb Oset (see page 60) will be shown until the button
is released.
Rev.Offset
10
-
0%
This parameter is stored automatically when leaving the screen, there is no need
to store the setting manually.