Kaypro 10 - Rebuilding System Tracks

REBUILDING SYSTEM TRACKS
If your KAYPRO 10 fails to boot, it may be because the hard disk has lost its
system tracks. Also, if the graphics system fails completely , it may be because
the system tracks also contain overlays for the graphics. In either instance, if
you have backed up user 0 on diskette, you can rebuild the tracks by doing the
following:
1. Insert the backup diskette of user 0 in the drive
2. Reset the computer .
3. Type: d
Press RETURN.
4. Type d b:
Press RETURN.
Remember, since you used a diskette to boot, drive C is now drive A; drive
A is now drive B. (
.
5. Compare the two directories . If they are the same, proceed. If they are not
the same , PIP the entire diskette onto B0 by typing:
PIP B: = A:*. *[OV]
6. Type: PUTSYS
Press RETURN. You will see: PUTSYS VER X.X
7. Type: PUTOVL
Press RETURN. You will see: PUTOVL VER X.X
8. Remove the diskette from drive C.
9. Reset the computer by pressing the reset button. Your computer should
now boot. If it doesn't , return the computer to your dealer for service.
74