Kaypro 10 - Video Command Protocol for KAYPRO 10

)
(
VIDEO COMMAND PROTOCOL FOR KAYPRO 10
The KAYPRO video section was designed to imitate most of the control se-
quences of a Lear-Siegler ADM-3A terminal. For most commercial software,
this means you can "install" or customize the display characteristics by choos-
ing ADM-3A from the menu. For
custom software or those instances where
there is no choice of "ADM-3A" on the menu, the complete command protocol
for the KAYPRO 10 is:
Control Characters
Action
Ring bell
Cursor left (non-destructive)
Cursor
right
Cursor down
Cursor up
Erase to end
of screen
Erase to end
of line
Clear screen, home cursor
Home cursor
ESCape Sequences
Insert line
Delete line
Cursor address
Reverse video
start
Reverse video stop
Half intensity start
Half intenSity stop
Blinking start
Blinking stop
Underline start
Underline stop
Cursor on
Cursor off
Video mode on
I\(r
"'fl
"L.
AJ
AK.
AW
Ax:
Al
""
77
Dec Hex
07 07
08 08
12
0C
10 0A
11
0B
23 17
24 18
26 1A
30
1E
ESCape,R
ESCape,E
ESCape,
= ,r ow + 32,col + 32
ESCape,B,0
ESCape,C,0
ESCape,
B,1
ESCape,C,1
ESCape,B,2
ESCape,C,2
ESCape,B,3
ESCape,C,3
ESCape,B,4
ESCape,C,4
ESCape,B,5