Kaypro 10 - COPYING FILES FROM ONE USER AREA INTO ANOTHER USER AREA

)
)
COPYING FILES FROM ONE USER AREA
INTO ANOTHER USER AREA
This procedure must
be done from drive A. If you are not in drive A, at the B> prompt,
type:
A:
Press RETURN.
1. Type: user
2. Type the number of the user area into which you want to copy the files, for
example: user 10
Press RETURN.
3. To copy a file from (for example) user area 2 into . the currently-logged user
area on drive A, substitute the name of your file for filename and type:
PIP A: = A:filename[G2]
(G stands for Get.)
Press RETURN.
Warm
Boot will appear when the file is copied. To check to see whether the
file has been copied, type: DIR
The square brackets must be square brackets, not parentheses.
To correct an error in typing, use the BACKSPACE key.
If there is an INVALID FORMAT error message, check very carefully to see
that everything is typed correctly.
4. To copy all files from one user area into another user area, for example, user
area 2, the command form is: pip a:=a:*.*[g2]
There will be a COPYING - notation with the name of the files appearing as
each is
finished copying.
5. You can copy a file from a user area in drive A to the user area of the same
number in drive B. Type: b: = a:filename
34