Kaypro 10 - Page 124

Creating file - B:MUFBAR .001
Closing file - B:MUFBAR .001
Closing file - A:FILEA .DAT
Opening file - A:FILEB .DAT
Creating file - B:MUFBAR .002
Insert next disk and type the
destination drive name (A - P) __
The MUFBACK program creates the destination files automatically with
the names MUFBAR.001, MUFBAR.002, MUFBAR.003 ... etc. These numbers
are in hexadecimal notation ( ... 008, 009, 00A, ... 00F, 010, ... ). A new MUF-
BAR file is opened after each source file is read or whenever the floppy
disk becomes full. Any previous file using this name will be removed, and
an
empty file will be created and filled.
The "Insert next..." message means that the first destination disk is full.
If
you get a DIRECTORY FULL prompt, change disks as usual, and the
same file will be re-opened on the next disk .
If you get a DISK FULL, DELETING FILE - message, MUFBAR is deleting a
partially -opened file from a full disk . Just change disks as usual, and the
same
file will be reopened on the next disk.
9. Change flexible disks.
10.
Specify a drive for the next file by typing the drive letter and a colon. Recall
that all destination files must be on a different drive from the source.
Press RETURN.
If you get the message, READ ERROR ... BACKUP ABORTED, there was a
system
level disk 1/0 error on a read operation. Try to re-run MUFBACK
from scratch. If the error persists, you have a system problem.
You will continue to be asked for new destination disks until all of the
source files have been transferred. The program will terminate with the
message: "END OF BACKUP. ALL FILES CLOSED ." You have success-
fully completed the backup process.
86