Kaypro 10 - Page 53

o
)
3. A new file screen will appear, and you can start writing.
There are two essential commands that should be learned immediately.
The Save File Command
After you have written some text, save that text by holding down the CTRL key
while pressing the X key (this will be designated as CTRL-X); then hold down the
CTRL key while pressing the S key (CTRL·S). So, the Save File command is:
CTRL·X CTRL-S
In the bottom left corner of the screen, you will see the message, Writing ... , as
the file is being saved. The message, File Written, will appear when the file has
been completely saved.
The
Close File Command
When you're through writing, first save the file. Then close the file by typing:
CTRL·X CTRL-C
For complete information, consult the Perfect Writer User's Guide.
Note: For information concerning configuring Perfect Writer for your printer,
refer
to the Technical Information section of this User's Guide and to the Perfect
Writer manual.
41