Kaypro 10 - VIDEO COMMAND PROTOCOL FOR KAYPRO 10

VIDEO SOFTWARE DRIVER
The KAYPRO 10 video section was designed to imitate the control sequences of (
a
Lear-Siegler ADM-3A terminal. For most commercial software, this means you
can
"install" or customize the display characteristics by choosing the ADM-3A
from the menu. For custom software or those instances where there is no
choice of "ADM-3A" on the menu, the following information may help.
VIDEO CONTROL SEQUENCES
(those similar to ADM-3A)
Designation Dec
[HEX]
Action
Bell
07 /\&
[07] Beep sent to keyboard
Backspace
08 "H
[08] Non-destructive cursor left
Line Feed 10
AJ
[OA] Cursor down
Vertical Tab 11
"I(
[OB] t-
Cursor up (scr en does not scroll)
Form Feed 12
At.
[O ~ ]
CvvY)u-( "'l -
ETB 23
A Vol
[17] Clear to end of screen
Cancel
24
" x
[18] Clear to end of line
Substitute 26
"7-
[1A] Clear screen (also home cursor)
Record
Seq.
30
A/\
[1 E] Home cursor
86