V2.01
25359_EDEBDA0279-2320-1_EN
13
Control and display panel
The controls in the compensation systems are preset.
The following parameters need to be checked or set:
Target cos phi in accordance with the electricity supplier regulations
(for kVA tari cos phi = 1)
Primary current and secondary current in accordance with input current transformer.
Voltage transformer ratio, if required
NOTE
Upon delivery, the bus protocol is set to:
Modbus RTU, baud rate 38400, parity even
This setting can only be changed manually on the device.
Performing a "Reset to default settings" has no eect on changed settings.
To Next Page
Loading...
Need help?
General
