KeContact P20 Installation
Installation manual, Version: 1.41 / Article no.: 90064 27
© KEBA 2012-2013
Opening the supply terminal
Opening the supply terminal
► Push the screwdriver with moderate force
straight
into the terminal until the wire
connector is completely open.
During pushing into the supply terminal,
the angle of the screwdriver is changing.
ATTENTION
Risk of breaking the terminal!
Do not pry the screwdriver up,
down or to the side!
Connecting the wire
Connecting the wire
► Push the stripped connection wire into the
supply terminal as shown on the picture.
Closing the terminal
Closing the terminal
► Pull the screwdriver completely out of the
supply terminal to close it.
► Check the firm seating of the wire.
► Connect the other wires in the same way.
To Next Page
Loading...
