ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
- 16 -
seconds, the meter will automatically return to display1 after 5 seconds, and the
original record content will be saved.
○ Automatically Prompt Interface
Error Code Display：
When the electronic control system of the electric vehicle fails, and the meter will
automatically display (flicker) fault code. You can’t exit the fault code display only the
fault is removed.
Error Code Display
Error Code & Definition Table：
Motor Hall Signal Abnormality
Torque sensor Signal Abnormality
Axis speed sensor Abnormality(only applied to torque sensor )
Motor or controller has short circuit Abnormality
Motor operating temperature alarm：
Under any interface, when the motor operating temperature exceeds the warning value,
the motor operating temperature display flashes to alarm, meanwhile, the controller will
offer the appropriate protection to motor.
User Setting Project
KT-LCD3 meter user setting project：
◇ General project setting
◇ P parameter setting
◇ C parameter setting
To Next Page
Loading...