KEC KT-LCD3 - C5 Controller Maximum Current Adjustment Mode

ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
- 25 -
○ C3 Power Assist Ratio Gear Initialization Mode
Enter C3 parameter setting interface after C2 parameter setting is finished, C3
parameter column flashes.
C3 parameter setting interface
C3 is initialization mode of power assist ratio gear. The setting range is 0-6 (gear),
hold button (UP) or button (DOWN) for selection. When C3 setting is 0, the
meter is switched on, and the power assist ratio is at gear 0. When the setting is 1, the
meter is powered on and the power assist ratio is at gear 1, and so on.
After finishing C3 parameter setting, hold button (SW) shortly to save the
current set values and enter C4 parameter setting interface.
○ C4 Handlebar Function Setting Mode
Enter C4 parameter setting interface after C3 parameter setting is finished, C4
parameter column flashes.
C4 parameter setting interface
C4 is handlebar function setting mode. The setting range is 0-4, hold button
(UP) or button (DOWN) for selection.
C4 parameter definition table：