KEC KT-LCD3 - C12 Controller Minimum Voltage Adjustment Mode

ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
- 31 -
C10 parameter setting interface
C10 is automatic restore default settings mode. The default is n, and the setting can be
n, or y, hold button (UP) or button (DOWN) shortly for selection.
C10 parameter definition table：
C10 value
Restore default setting
n
Function off
y
Function on
When the meter is needed to restore default setting, C10 selects y, hold button
long for about 2 seconds, all parameters restore default settings and exit setting
environment, and then return to the display1.
C10 selects n, hold button (SW) shortly to save the current set values and enter
C11 parameter setting interface.
○ C11 Attribute Selection Mode
Enter C11 parameter setting interface after C10 parameter setting is finished, C11
parameter column flashes.
C11 parameter setting interface
C11 is meter attribute selection mode. The setting range is 0-2, hold button