KEC KT-LCD3 - C13 ABS Brakes of the Controller and Parameters of Anti-Charge Control

ELECTRIC BICYCLE METER KT—LCD3 Product User Manual
- 32 -
(UP) or button (DOWN) shortly for selection.
C11 parameter definition table：
C11
value
Meter Attribute
0
Meter uses LCD3 new version of communication protocol, it is compatible
LCD1 and LCD2.
1
Meter uses LCD1 and LCD2 old version communication protocol, it is not
compatible LCD3.
2
As data source for copying parameters, the meter transfers the new LD3
parameter to other meters.
C11 selects 2, hold (SW) long for about 2 seconds to exit the setting
environment, and then the meter is served as data source for copying parameter (see
parameter copy), there’s source logo on display interface.
Data Source Display Interface
After finishing C11 parameter setting, hold button (SW) shortly to save the
current set values and enter C12 parameter setting interface.
○ C12 Controller Minimum Voltage Adjustment Mode
Enter C12 parameter setting interface after C11 parameter setting is finished, C12
parameter column flashes.