30
SCPI command subsystems
Notes:
1. Brackets ([]) are used to denote optional character
sets. These optional characters do not have to be
included in the program message. Do not use
brackets in the program message.
2. Angle brackets (<>) are used to indicate parameter
type. Do not use angle brackets in the program
message.
3. Upper case characters indicate the short-from ver-
sion for each command word.
Table 5. Signal oriented measurement commands
Command Description
:CONFigure:<function>
:FETCh?
:READ?
MEASure[:<function>]?
Places the Model 2000 in a “one-
shot” measurement mode for the
specified function.
Requests the latest reading.
Performs an :ABORt, :INITiate, and a
:FETCh?.
Performs an :ABORt, :CONFig-
ure:<function>, and a :READ?.
2000-903-01A Page 30 Thursday, December 23, 1999 7:52 AM
To Next Page
Loading...
