Keithley 2000 - Page 39

36
:VOLTage:AC
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
:AVERage
:TCONtrol <name>
:TCONtrol?
:COUNt <n>
:COUNt?
:STATe <b>
:STATe?
:DETector
:BANDwidth <NRf>
:BANDwidth?
Enable or disable reference.
Query state of reference.
Use input signal as reference.
Query reference value.
Specify measurement resolution
(4 to 7).
Query resolution.
Path to configure and control the
filter.
Select filter type: (MOVing or
REPeat).
Query filter type.
Specify filter count (1 to 100).
Query filter count.
Enable or disable filter.
Query state of digital filter.
Path to configure bandwidth:
Specify bandwidth (3 to
300e3).
Query bandwidth.
:VOLTage:DC
:NPLCycles <n>
:NPLCycles?
:RANGe
[:UPPer] <n>
[:UPPer]?
:AUTO <b>
:AUTO?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
Path to configure DC voltage:
Set integration rate (line cycles;
(0.01 to 10).
Query line cycle integration rate.
Path to configure measurement
range:
Select range (0 to 1010).
Query range.
Enable or disable auto range.
Query auto range.
Specify reference (-1010 to
+1010).
Enable or disable reference.
Query state of reference (0 or
1).
Use input signal as reference.
Query reference value.
Specify measurement resolution
(4 to 7).
Query resolution.
Table 10. SENSe command summary (cont.)
Command Description
2000-903-01A Page 36 Thursday, December 23, 1999 7:52 AM