Keithley 2601B Reference Manual

Series 2600B
System SourceMeter® Instrument Reference Manual Section 6:
Instrument programming
2600BS-901-01 Rev. B / May 2013 6-61
To setup communication to a remote ethernet device that is not TSP enabled:
1. Send the command:
connectionID = tspnet.connect(ipAddress, portNumber, initString)
Where:
• connectionID is the connection ID that will be used as a handle in all other TSP-Net function calls.
• ipAddress is the IP address of the remote device.
• portNumber is the port number of the remote device.
• initString is the initialization string that is to be sent to ipAddress.
See tspnet.connect() (on page 7-367) for additional detail.
To communicate to a remote ethernet device from the Series 2600B:
1. Connect to the remote device using one of the above procedures. If the Series 2600B cannot
make a connection to the remote device, it generates a timeout error. Use tspnet.timeout to
set the timeout value. The default timeout value is 20 seconds.
2. Use tspnet.write() or tspnet.execute() to send strings to a remote device. If you use:
• tspnet.write(): Strings are sent to the device exactly as indicated, and you must supply any
needed termination characters.
• tspnet.execute(): The Series 2600B appends termination characters to all strings that are sent.
Use tspnet.termination() to specify the termination character.
1. To retrieve responses from the remote instrument, use tspnet.read(). The Series 2600B
suspends operation until the remote device responds or a timeout error is generated. To check if
data is available from the remote instrument, use tspnet.readavailable().
2. Disconnect from the remote device using the tspnet.disconnect() function. Terminate all
remote connections using tspnet.reset().
Example script
The following example demonstrates how to connect to a remote device that is not TSP
®
enabled,
and send and receive data from this device:
-- Disconnect all existing TSP-Net connections.
tspnet.reset()
-- Set tspnet timeout to 5 seconds.
tspnet.timeout = 5
-- Establish connection to another device with IP address 192.168.1.51
-- at port 1394.
id_instr = tspnet.connect("192.168.1.51", 1394, "*rst\r\n")
-- Print the device ID from connect string.
print("ID is: ", id_instr)
-- Set the termination character to CRLF. You must do this
-- for each connection after the connection has been made.
tspnet.termination(id_instr, tspnet.TERM_CRLF)
-- Send the command string to the connected device.
tspnet.write(id_instr, "*idn?" .. "\r\n")
-- Read the data available, then print it.
print("instrument write/read returns: ", tspnet.read(id_instr))
-- Disconnect all existing TSP-Net sessions.
tspnet.reset()

Keithley 2601B Specifications

General

Brand	Keithley
Model	2601B
Category	Measuring Instruments
Language	English