Keithley 2601B

Section
6: Instrument programming Series 2600B System SourceMeter® Instrument
Reference Manual
6-42 2600BS-901-01 Rev. B / May 2013
Figure 116: Create a new script with the name of an existing script
Rename a script
You can rename a script. You might want to rename a script if you need to name another script the
same name as the existing script. You could also rename an existing script to be the autoexec script.
To change the name of a script, use the command:
scriptVar.name = "renamedScript"
Where:
scriptVar
=
The global variable name
"renamedScript"
=
The new name of the user script that was referenced by the scriptVar
global variable
After changing the name, you need to save the original script to save the change to the name
attribute.
For example:
beepTwoSec.name = "beep2sec"
beepTwoSec.save()
Run the beep2sec script using the following command:
script.user.scripts.beep2sec()