8: Grading and binning resistors Model DMM7510 7½ Digit Multimeter
8-4 DMM7510-900-01 Rev. B / May 2015
Overview of the application
For this application, you will:
• Reset the instrument.
• Select the four-wire resistance function.
• Enable offset compensation.
• Auto zero once.
• Set up digital I/O lines 1 to 4 as outputs to component handler
• Set up digital I/O line 5 for trigger-model control, detecting the trigger as the start-of-test input
• Set up digital I/O line 6 as the end-of-test output notification
• Initiate the GradeBinning trigger-model template
• Display "Test Completed" message on the front panel
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
