EasyManua.ls Logo

Keithley DMM7510 - Integrating with a Model 3706 A-S using TSP-Link

Keithley DMM7510
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
In this section:
Introduction .............................................................................. 9-1
Equipment required .................................................................. 9-1
Device connections .................................................................. 9-2
Integrating with a Model 3706A-S test ..................................... 9-4
Introduction
This application example demonstrates how to configure the Model DMM7510 and Model 3706A-S
System Switch to interact through TSP-Link. The application measures different types of signals on
multiple channels in multiple slots of a Model 3706A-S.
This is a common production test setup that monitors a variety of signals. These signals are typically
routed through a switch that can accommodate the performance and throughput of the test
requirement.
The example includes:
30 channels that measure DC voltage at two different ranges in slot 1
10 channels that measure AC voltage in slot 1
20 channels that measure 4-wire resistance in slot 4
Equipment required
This application requires the following equipment:
One Model DMM7510
One Model 3706A-S Six-Slot System Switch
One Model 3721 Dual 1x20 Channel Multiplexer Card and Model 3721-ST Screw Terminal Block
One Model 3724 Dual 1x30 FET Multiplexer Card and Model 3724-ST Screw Terminal Block
Multiple devices or components to be tested
Several insulated banana cables (such as the Model 1756 Standard Test Lead Kit that is
provided with the Model DMM7510)
One computer set up for communication with the Model DMM7510
Section 9
Integrating with a Model 3706A-S using TSP-Link
北京海洋兴业科技股份有限公司(证券代码:839145)
电话:010-62176775
网址:www.hyxyyq.com

Table of Contents

Other manuals for Keithley DMM7510

Related product manuals