To Next Page

To Previous Page

3.3 OPERATION OF COOLING FAN

FastMig Pulse power sources incorporate two simultaneously operating fans.

• The fan is started momentarily when the main switch is placed into position - I.

• The fan will start during welding as the machine reaches operational temperature, and

it will run for 1 to 10 minutes after the welding has stopped, depending on the welding

cycle completed.

3.4 MANUAL METAL ARC WELDING

FastMig Pulse power source can be used for MMA electrode welding by connecting the

FastMig MXF wire feeding unit and PF function panel. MMA function is optional in FastMig

Pulse equipment, and therefore can be activated by purchasing the appropriate licence for the

MMA process. Please see ordering number codes. FastMig Pulse power source will not support

the MMA process without an MXF wire feeder connected.

4. USING THE MACHINE

Welding applications vary, so the equipment must adapt. FastMig Pulse features Arc Wizard

P65 interface, a clear and logical LCD menu display. Arc Wizard menu allows the operator

to rene, adapt and manage the arc process and system function before, during and after

welding.

4.1 ARC WIZARD, SETUP PANEL P65  LAYOUT

CHANNEL

INFO

USER

WF #

F1 F2 F3

P 65

W003989

1. 4.

5.6.

2. 7. 3.

4.2 SETUP PANEL P65  QUICK GUIDE

The following information details P65 panel operation and set-up. Additional information

is also available in the printed 'Quick Guide' for P65 and PF function panels. Quick Guide is

included in the delivery package, plus pdf copy recorded to CD.

Introduction to P65 button functions

1. Switch P65 ON/OFF by long pressing on this button (approximately 5 seconds). Also returns

channel information display by short press.

NOTE! For true ON/OFF switching of the mains power, use the main switch I/O – ON/OFF located

on the front of the power source.

Kemppi 350 User Manual

Questions and Answers: