Kemppi MF 33 Service Manual

Error codes
Power source 1 ..... 50
MIG Logic 51 ….. 100
Curve Access 101 ….. 130
Robot Interface 131 ….. 150
MIG / TIG Unit 151 ….. 200
User interface 201 ….. 250
Others 0 ….. 999
Err 2: Power source undervoltage ( new start up )
Err 3: Power source overvoltage ( new start up )
Err 4: Power source is overheated
Err 5: Water unit alarm
Err 11: Two units have the same address in the system bus
Err 12: Data error on communication (2)
Err 13: Member of a wrong FastMIG family connected
Err 14: Data communication problem between power source and auxiliary unit
Err 15: Power source program / updating method problem
Err 21: Power source´s control card +5 V aux. Voltage too low
Err 22: Power source´s control card +15 V aux. Voltage too low
Err 23: Temporarily power source overvoltage
Err 31: Power source calibration error. Welding only possible with default values.
Err 54: No data communication from power source. Perhaps faulty cable/connector.
Err 55: Welding forbidden (congiguration / system bus reserved)
Err 61: The water unit is not found. Cooling unit may be OFF.
Err 153: Overheating of liquid-cooled gun
Err 154: Wire feed motor overcurrent. Perhaps the wire liner is blocked or gun cable too curvy.
Err 155: Wire feed motor overload. Motor´s current is too close to the limit.
Err 161: Warning of the wire feed unit overheating
Err 162: Overloading of the wire feed motor
Err 171: Configuration of the equipment can not be found. Gun start wires cross-connected.
Err 172: Wrong configuration code has been supplied
Err 173: Operation is not activated with right configuration code
Err 184: Control cable not connected or faulty.
Err 185: Machine program update error. Wrong program or updating method.
Err 201: Usage of PMT-gun prevented
Err 221: Data error of the panel (1)
Err 222: Data error of the panel (2)
Err 223: Data error of the panel (3)
Err 224: Data error of the panel (4)
Err 225: Program updating problem.
Err 241: EEPROM is faulty
Err 251: DLI data communication error(another unit in the bus is using same code=conflict)
Err 252: DLI data error (2)
Err 254: DLI data communication error(connection to other units has been interrupted(maybe bad connectors or cable
damages)
Err 255: DLI data communication error(program update problem, maybe a wrong program version etc)
Err 999: Unidentified error (systembus has sent an error message not identified by the panel)
27

Kemppi MF 33 Specifications

General

Brand	Kemppi
Model	MF 33
Category	Welding System
Language	English