Kentec Electronics Sigma XT K11031F2 - Tell Tale

40 pages

Save Page as PDF

To Next Page

To Previous Page

Product Manuals/Man-1088_Sigma XT_26 Page 33 of 40

19.16 Tell tale

Indicates that either panel mounted or remote manual release button has been pressed.

Can only be reset by pressing processor reset and W/DOG reset or powering down the control

panel.

Main Page

Default Chapter2
- Table of Contents2
1 Introduction4
2 Safety and Mounting5
- Safety5
- Mounting6
3 Technical Specification7
4 Control Panel Fascia10
5 Connecting to the Circuit Board12
6 Detection Zone Wiring13
7 Sounder Circuit Wiring13
8 Using Intrinsically Safe Barriers14
9 Connection to Monitored Inputs15
10 Connection to Extinguishant Output15
- Solenoid Wiring15
- Igniting Actuator Wiring16
- Setting up Extinguishant Monitoring Circuit16
- Adjustment16
- For 3 or more Actuators17
- For 1 or 2 Actuators17
11 Connection to Remote Control Terminals18
12 Aux 24V DC Supply18
13 Connection to Relay Contacts19
- Fault Relay19
- Local Fire Relay19
- Fire Relay19
- St Stage Alarm19
- Nd Stage Alarm19
- Extract Relay19
14 Connection and Configuration of Status Units and Ancillary Boards20
- Adding New Status Units/Ancillary Boards20
- Removing Status Units/Ancillary Boards21
15 Panel Operation21
- Normal Condition21
- Single Zone Fire Condition21
- Double Zone Fire Condition22
- Manual Release22
- Silence/Sound Alarms22
- Reset22
- Zone Fault22
- Sounder Fault22
- Power Fault22
- System Fault23
- General Fault23
- Lamp Test23
- Hold Condition23
- Released Condition23
- Low Pressure Switch23
- Test Mode23
- Change Mode24
- Extract Fan24
- Disablements24
16 Access Level 2 Configuration Options25
- T1 - 3] Test Zone25
- D1 - 3] Disable Zone25
- Db] Disable First Stage Sounders25
- Dp] Disable (Pre-Activated) First Stage Relay Contact26
- Da] Disable (Activated) Second Stage Relay Contact26
- DC] Disable Extract Fan Relay26
- Dt] Disable Manual Triggering Device (Manual Release)26
- De] Disable Extinguishant Release26
- Ad] Activate Delays26
- Ac] Operate Extract Fan Output26
17 Access Level 3 Configuration Options27
18 Internal Controls30
- Watchdog Reset30
- Processor Reset30
- Terminate Extinguishant30
- Commissioning30
- 19 Internal Indications - Troubleshooting31
20 Power Supply34
21 Maintenance35
22 Record of Configuration35
23 CE Mark39
24 Commissioning Instructions40

Kentec Electronics Sigma XT K11031F2 - Tell Tale

Table of Contents

Related product manuals