2. Safety and mounting
2.1 Safety
Suppliers of articles for use at work are required under section 6 of the Health and Safety at Work
act 1974 to ensure as reasonably as is practical that the article will be safe and without risk to
health when properly used.
An article is not regarded as properly used if it is used ‘without regard to any relevant information
or advice’ relating to its use made available by the supplier.
This product should be installed, commissioned and maintained by trained service personnel in
accordance with the following:
(i) IEE regulations for electrical equipment in buildings
(ii) Codes of practice
(iii) Statutory requirements
(iv) Any instructions specifically advised by the manufacturer
According to the provisions of the Act you are therefore requested to take such steps as are
necessary to ensure that you make any appropriate information about this product available to
anyone concerned with its use.
This equipment is designed to operate from 230V 50Hz mains supplies and is of class 1
construction. As such it must be connected to a protective earthing conductor in the fixed wiring
of the installation and a readily accessible double pole disconnect device meeting the
requirements of EN60950/IEC950 which disconnects live and neutral simultaneously shall be
incorporated in the fixed wiring.
Switch disconnect devices such as MK Sentry 63A or similar are suitable for this.
Failure to ensure that all conductive accessible parts of this equipment are adequately
bonded to the protective earth will render the equipment unsafe.
This control panel is environmental class A and is designed for indoor use only at temperatures
between -5
0
C (+/- 3) and +40
0
C (+/- 2) and with a maximum relative humidity of 95%.
The IP rating for the enclosure is IP30.
Operation outside of these limits may render the equipment unsafe.
To Next Page
Loading...
