Kenwood CS-5200 Series - Page 11

Items
CS-5230, 5235
CS-5260, 5265 CS-5270, 5275
Chop frequency
Approx. 250 kHz (in multi-trace operation)
Channel polarity
Normal or inverted, CH2 only inverted
Horizontal axis (CH2, except for X10 MAG operation)
Sensitivity (+10 to +35°C)
Same as vertical axis (CH2)
Input impedance
Same as vertical axis (CH2)
Frequency response (-3 dB)
(+10 to +35
r
C)
DC: DC to 1 MHz, AC: 5 Hz to 1 MHz
X-Y phase difference
3° or less at 100 kHz
Operation mode
X-Y mode is selected with H. MODE
CHI: Y-axis, CH2: X-axis
AMaximum input voltage
Same as vertical axis (CH2)
SWEEP
Sweep types
A : A sweep
ALT : Alternate A sweep and B sweep
B : B sweep
X-Y : X-Y oscilloscope operation
Sweep time
(+10 to +35°C)
A sweep
0. 5s to 0. l//s/div
±3X
1-2-5 steps,
21 ranges,
fine adjustment
between ranges
0.5s to 50ns/div
±3%
1-2-5 steps,
22 ranges,
fine adjustment
between ranges
Sweep time
(+10 to +35°C)
B sweep
50ms to 0.1/is/div
±3%
1-2-5 steps,
18 ranges,
fine adjustment
betwen ranges
50ms to 50ns/div
±3%
1-2-5 steps,
19 ranges,
fine adjustment
betwen ranges - •
Sweep magnified operation
( + 10 to +35°C)
X10 ± 5% (±8X for over 0.5 ns/div)
Linearity ( + 10 to + 35°C)
±3% (±5% in xlO MAG operation)
H0LD0FF
Continuously variable from A sweep NORM position
Trace separation
B sweep is continuously variable by ±4 divisions or more
with respect to A sweep.
Delayed sweep operation
Continuous delay operation (AFTER DELAY)
Synchronous delay operation (B TRG
?
D) : Synchronous with
the trigger signal
Delay time
Continuous control by 0. 2 to 10 divisions for 0. 5 div to
maximum speed sweep
Delay time error
( + 10 to +35°C)
[CS-5235 5265 5275]:
±(3X of set value + lX of full scale) + (0 to 300 ns)
[CS-5235, 5265, 5275]:
Reading on CRT ±41 (0 to 300 ns)
Delay jitter
10000 : 1 of a value 10 times as high as A sweep setting
7