Adjusting the volume
You can adjust the volume (00 to 40)
by pressing VOL J to increase and
pressing VOL
K to decrease.
• When volume level is below 15,
holding VOL J increases the
volume continuously to level 15.
Attenuating the sound
On the source control screen:
To cancel attenuation:
Initial settings
When you power on the unit for the first time or
initialised, the <Initial Setup> screen appears.
Perform the initial settings.
Initial Setup
Finish
Language
English (UK)
Rear Camera
Enter
User Customize
Enter
Enter
Demonstration ON OFF
Viewing Angle
Enter
Once completed, Home screen appears.
<Demonstration> (page 42)
• ON (Initial): Activates the display demonstration.
• OFF: Deactivates the display demonstration.
<Language> (page 44)
Select the text language used for on-screen
information.
• English (American English)/English (UK)(Initial)
/
Русский/ /Türkçe/ / /Bahasa
Malaysia/Bahasa Indonesia
• GUI Language: Local (the language selected above)
(Initial)/English: Selects the language used for
displaying operation keys and menu items.
<Rear Camera> (page 43)
Make the settings to display the picture from the
connected rear view camera.
<User Customize> (page 41)
Change the display design.
<Viewing Angle> (page 42)
Select the viewing angle in relation to the monitor to
make the image on the screen easier to see.
• Under 0° (Initial)/5°/10°/15°/20°
Putting the unit in standby
1 Display the source/option selection
screen.
From the Home screen (page 3), touch as
follows:
2 Put the unit in standby.
On the source/option selection screen (page 12):
Turning off the screen
On the monitor panel
To turn on the screen: Press
the DISP OFF button on the
monitor panel or touch the
screen.
On the pop-up menu
To turn on the screen: Touch the screen.
(Hold)
Component Names and Basic OperationsComponent Names and Basic Operations
4
ENGLISH
00DMX7522DABSX.indb400DMX7522DABSX.indb4 2022/11/1513:312022/11/1513:31
To Next Page
Loading...
Need help?
General
