User’s Manual
Published on February 2017 UMn°154 – rev.05 6
This document and any information disclosed herein are the property of Keopsys and constitutes and contains proprietary information.
Receipt or possession of this document does not confer or transfer any right to duplicate, use disclose any information
1.2.3. Class III-B Laser product
The KEOPSYS products comply with the European and International normalization about laser safety
and optical fibers telecommunication systems safety:
• IEC 60825-1
• IEC 60825-2
So following symbols appear on the product:
LASER WARNING Label
(located on the front panel or the lid)
EXPLANATORY Label
LASER RADIATION WARNING Label
(located on the front panel or the lid)
Label for panel
(located on the cover or the lid)
Electrical Warning and Compliance located on
the right side of the rear panel
Class III-B Laser safety:
Class III-b laser product may emit 500 mW max of light in the 1000 nm -1700 nm
range.
The use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure
Use appropriated and standardized laser glasses.
The use of optical instruments with this product will increase eye hazard.
Do not under any circumstances look directly into the fiber end of an optical cable
attached to the optical output while the device is in use.This may cause permanent
eye or skin damages and possible loss of eyesight.
Disable the laser output before connecting or disconnecting an optical fiber
cable on the instrument.
Do not open the device. Invisible laser radiation could affect the operator if this
condition is not respected.
Any check of the optical connectors must be processed when the laser source
is unplugged and by using filtering observation optical systems.
The device must operate without any impact or vibration.
To Next Page
Loading...