KEOPSYS CEFA-C-PB-HP - Class IV Laser Product; Electric Safety

User’s Manual
Published on February 2017 UMn°154 – rev.05 7
This document and any information disclosed herein are the property of Keopsys and constitutes and contains proprietary information.
Receipt or possession of this document does not confer or transfer any right to duplicate, use disclose any information
1.2.4. Class IV Laser product
The KEOPSYS products comply with the European and International normalization about laser safety
and optical fibers telecommunication systems safety:
• IEC 60825-1
• IEC 60825-2
So following symbols appear on the product:
LASER WARNING Label
(located on the front panel or the lid)
EXPLANATORY Label
LASER RADIATION WARNING Label
(located on the front panel or the lid)
.
Label for panel
(located on the cover or the lid)
Electrical Warning and Compliance located on
the right side of the rear panel
Class IV Laser safety:
WARNING
Class IV laser product may emit more than 500 mW of light in the 1000 nm -1700 nm
range.
WARNING
The use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
WARNING
Use appropriated and standardized laser glasses.
WARNING
The use of optical instruments with this product will increase eye hazard.
Do not under any circumstances look directly into the fiber end of an optical cable
attached to the optical output while the device is in use for this may cause permanent
eye or skin damages and possible loss of eyesight.
WARNING
Disable the laser output before connecting or disconnecting an optic fiber cable
on the instrument.
WARNING
Do not open the device.
Invisible laser radiation could affect the operator if this condition is not respected.
WARNING
Any check of the optical connectors must be processed when the laser source is not
supplied and by filtering observation optical systems.
WARNING
The device must operate without any impact or vibration.
1.2.5. Electric Safety
The KEOPSYS products comply with the European and International normalization EN 61010 d03.
WARNING
Before connecting your device make sure that the socket outlet is properly grounded
WARNING
Before connecting your device make sure that your line voltage agrees with the voltage
given on documentation and sticker on the unit and that the right fuse has been inserted