34 KFS-TM-BA_IA-e-1920
7.8 Tolerance check
The weighing scales allow weighing goods according to a target quantity or target
weight within specified tolerances. With this function one can also check if the
weighing good is within a defined tolerance range. Reaching target quantity is
indicated by an audio sound (if enabled in menu) and a visual signal
(Tolerance margin ) displayed.
For menu settings, see chapter 8:
Target quantity / target
weight with tolerances
2 limits For menu setting, „F3 Pn ”
see chap. 8
Accurate target quantity /
accurate target weight
without tolerance
1 limit For menu setting, „F3 Pn ”
see chap. 8
Audio signal:
The audio sound depends on the settings made in menu block “F4 bU“, see chap. 8.
Options:
Acoustic signal turned off
14 bu 1 Audio signal will ring out when load is within tolerance range.
14 bu 2 Audio signal will ring out when load is beyond tolerance range.
Optical signal:
The triangular tolerance marker [ ] in the display of the display shows whether the
goods to be weighed are within the two tolerance limits.
Target quantity / target weight exceeds maximum tolerance limit
Target quantity / target weight within tolerance range
Target quantity / target weight below minimum tolerance limit
To Next Page
Loading...
