KERN KFS-TM User Manual

KFS-TM-BA_IA-e-1920 53
8.1 Overview not verifiable weighing systems
(in the configuration menu select the menu item F3 APP Setting „off“)
Menu item Available settings
F0 SEL
Enable tolerance check
1 SEL0
Tolerance control disabled
1 SEL1
Tolerance control for weighing
1 SEL2*
Tolerance control for counting
F1 Co
Display conditions of the tolerance
marker
11 Co0
Tolerance marker is always displayed, even if
standstill control is not yet displayed.
11 Co 1*
Tolerance marker is only displayed in connection
with standstill control.
F2 Li
Tolerance range
12 Li 0
Tolerance marker is only displayed above zero
range.
12 Li 1*
Tolerance marker is displayed for the whole
range.
F3 Pn
Number of limiting points
13 Pn 0
1- Limiting point (OK/ -)
13 Pn 1*
2- Limiting points (+/OK/-)
F4 bU
Audio signal
14 bu0*
Audio sound during tolerance control disabled
14 bu1
Audio sound when load is within tolerance limits
14 bu2
Audio sound when load is beyond tolerance limits
F5 Ao
Automatic zero point correction
(zero tracking)
2 Ao0
Automatic zero tracking off
2 Ao1
Automatic limiting point correction on, 0.5 d
2 Ao2*
Automatic limiting point correction on, 1 d
2 Ao3
Automatic limiting point correction on, 2 d
2 Ao4
Automatic limiting point correction on, 4 d
F6 At
Auto-Tare
on
Auto-Tare enabled
off
Auto-Tare not enabled
F7 AP
Automatic shutdown for battery
operation
3 Ap0*
AUTO OFF function disabled
3 Ap1
Instrument will be switched off after 3 minutes of
inactivity of display unit or weighing bridge.

KERN KFS-TM Specifications

General

Brand	KERN
Model	KFS-TM
Category	Monitor
Language	English