KN-4006 series UV Radiation Treatment System
open it. Then press key to set the system time.
3. System time setting is the same as irradiation time setting
way.
4. Finishing the function set, press “ /Ok” to end edit mode.
Treatment process
Ø Start
After irradiation time is over, press START key to run the
irradiator, and “ ” mark starts flashing, and voice note” “treatment
will be started, please wear googgles”. Warning tone “di” will be
used to be noted before light starts. When light is on, the device
begins to count down. If mark is on, UV has been output.
Note sound “treatment will be finished” will be showed in the
last one minute.
Ø pause
Press STOP to pause treatment, lamp will be turned off and
countdown will pause while work status indicates is " ". If is
pressed, lamp will be turned on to continue treatment and
countdown will go on.
Ø stop
When countdown is finished, the instrument will be
automatically shut down and end the treatment. “ ” mark will
twinkle. UV output mark is off.
To Next Page
