37
Keysight 16452A Liquid Test Fixture
Operation and Service Manual
4Service
Introduction
This chapter covers assembly replacement and troubleshooting information.
Assembly Replacement
Table 4-1, Table 4-2, and Table 4-3 list the support parts for RoHS and
non-RoHS compliance 16452A Liquid Test Fixture. All the listed items are
changed at RoHS conversion. Due to limited availability of RoHS compliance
station and technical difficulties in RoHS soldering, only parts and support
level that do not require RoHS soldering are supported. For RoHS Compliant
Upper Level Assembly Replacement Part, if multiple parts are replaced by a
common higher assembly part, only order ONE part of the higher level
common assembly. If the original support part (Non-RoHS Compliant
Replacement Part is obsolete, replaced the part by a higher common RoHS
Compliant assembly part. The parts listed can be ordered from your nearest
Keysight Technologies Office. Ordering information must include the Keysight
part number and the required quantity.
Serial Number for Non-RoHS 16452A:
JP44100001 – JP44299999/MY44100001 – MY44200319/
SG44100001 – SG44200319
Serial Number for RoHS 16452A:
MY44200320 and above/SG44200320 and above
These servicing instructions are for use by qualified personnel only. Do
NOT perform any servicing (other than that contained in the operating
section) unless you are qualified to do so.
To Next Page
Loading...