38 Keysight Models 6811C, 6812C, and 6813C Quick Start Guide
Basic Operations
Turn on the ac source. Use either the front panel keys or the corresponding SCPI
commands.
The text to the right describes the result. If appropriate, the resultant output
waveshape is shown underneath the description.
Action, key press, or display Result
Enable the output
1 Press .
The programmed voltage appears at the output and the Dis display on
the annunciator turns off.
Set the voltage
1 Press .
2 Press 120 on the keypad of
the Entry key group.
3 VOLT 120 is displayed.
4 Press [Enter].
The output voltage is set to 120 V rms.
Set the frequency
1 Press .
2 Press 50 on the keypad of
the Entry key group.
3 FREQ 50 is displayed.
4 Press [Enter].
The output frequency is set to 50 Hz.
To Next Page
Loading...
Need help?
General
