40 8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
2 Specific Commands
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep
:CHECkparams? Returns whether sweep parameters set are consistent. page 165
:CYCLes/? Sets or returns the number of cycles. page 166
:DWELl/? Sets or returns the dwell time. page 167
:EXP? Returns number of triggers (used to configure power meter). page 168
:FLAG? Returns whether waiting for trigger, or logging data available. page 169
:LLOGging/? Switches lambda logging on or off or queries the state of lambda logging. page 170
:MODE/? Sets or returns the sweep mode. page 171
:PMAX? Returns the highest permissible power for a wavelength sweep. page 171
:REPeat/? Sets or returns the repeat mode. page 173
:SOFTtrigger Sends a soft trigger. page 174
:SPEed/? Sets or returns the speed for continuous sweeping. page 174
:STARt/? Sets or returns the start point of the sweep. page 175
:STOP/? Sets or returns the end point of the sweep. page 176
[:STATe]/? Stops, starts, pauses or continues a wavelength sweep or returns the the state
of a sweep.
page 176
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep:STEP
:NEXT Performs the next sweep step. page 178
:PREVious Performs the previous sweep step again. page 178
[:WIDTh]/? Sets or returns the width of the sweep step. page 179
Command Description Page
To Next Page
Loading...
