Notices 6
Copyright Notice 6
Manual Part Number 6
Edition 6
Published by 6
Warranty 6
Technology Licenses 6
U.S. Government Rights 7
Waste Electrical and Electronic Equipment (WEEE) 7
Declarations of Conformity 7
Safety Information 8
Safety and Regulatory Information 9
Safety Considerations 9
Safety Symbols 10
Regulatory Markings 11
South Korean Class A EMC declaration: 11
Safety and EMC Requirements 11
Environmental Conditions 12
1 Getting Started 13
Introduction 14
Front panel 14
Rear panel 15
Display 16
Dimension diagram 17
Setup the instrument 17
Options and Fuse Information 18
Ensure the correct AC input voltage and fuse settings 18
Programming Ranges 20
Table of programming and readback resolutions 20
Extending the Voltage Range and Current Range 21
Series connections 21
Parallel connections 21
Front Panel Operation 22
Configure the LAN interface 22
Set voltage and current 23
Specify 2- or 4-wire measurement 23
Configure Overcurrent Protection (OCP) and Overvoltage Protection (OVP) 24
Clear an OCP or OVP event 24
Clear an overtemperature protection (OTP) event 25
Lock and unlock the front panel 25
Save or recall the instrument's state 26
Configure the Power-on State 26
Read error codes 26
Remote Control 27
Keysight IOLibraries Suite 27
E36100B Series Web interface 27
Technical connection details 29
Rack Mounting the Instrument 30
Rack mounting a single instrument 30
Rack mounting multiple instruments side-by-side 30
Keysight E36100B Series Operating and Service Guide 2
To Next Page
Loading...
