48 LCR Meter
2 Troubleshooting
Troubleshooting during Startup
When you encounter problems during start up, see Table 3.
System recovery saves most of problems.
Table 3 Troubleshooting during startup
Symptom Solution
Turning on (|) the standby switch does
not start up the system.
Confirm that the power cable is
properly plugged in.
Confirm that the line switch at the
rear panel is turned on.
The system starts up, but it automatically
shuts down immediately.
Execute the system recovery.
The system starts up, but it enters the
service mode (The status bar at the lower
right of the screen displays SVC in red).
To Next Page
Loading...
Need help?
General
