Utility Settings 20
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 295
File Explorer
The File Explorer lets you navigate the oscilloscope's internal file system and the
file systems of connected USB storage devices.
From the internal file system, you can load oscilloscope setup files or mask files.
From a connected USB storage device, you can load setup files, mask files, license
files, firmware update (*.ksx) files, label files, etc. Also, you can delete files on a
connected USB storage device.
The oscilloscope's internal file system, under "\User Files", consists of 10 locations
for oscilloscope setup files, and four locations for mask files.
To use the File Explorer:
1 Press [Utility] > File Explorer.
2 In the File Explorer Menu, press the softkey in the first position and use the
Entry knob to navigate.
The USB port on the front panel, and the USB port on the rear panel labeled "HOST" are USB
Series A receptacles. These are the receptacles to which you can connect USB mass storage
devices and printers.
The square receptacle on the rear panel labeled "DEVICE" is provided for controlling the
oscilloscope over USB. See the Programmer's Guide for more information.
To Next Page
Loading...
Need help?
General
