Keysight Agile Signal Generator Service Guide 115
Assembly Replacement
Microdeck Sub-Assemblies
To gain access to any of the microdeck sub-assemblies it is necessary to
remove the instrument outer cover and the inner bottom rear cover. Refer to
“Outer Cover” on page 99 and “Inner Bottom Covers” on page 101.
— A16 Frequency Multiplier
— A17 Agile Mod/Filter
— A18 Lowband Output Module
— A19 40 GHz Doubler - Option 540/54E Only
— A20 Output Leveling Assembly
It is not necessary to remove the Microdeck assembly from the instrument in order to replace
any of the Microdeck sub-assemblies listed above. All sub-assemblies can be removed and
replaced while the Microdeck is still installed in the instrument.
The procedures below are for a UNM instrument. If you have an Option 1EM (rear panel
connectors) it will be necessary to perform additional steps to remove the rear panel cables.
To Next Page
Loading...
Need help?
General
