2 Installing the N1000A
6. Visually check that all ESD sensitive parts, assemblies, or products are com-
pletely inside closed conductive containers.
7. Make sure that all shielding containers have an approved static attention
label on the outside.
8. Make sure that all cleaners, solvents, coatings, and sprays used at your
workstation are types approved by your ESD Coordinator.
9. Put on wrist strap and conductive footwear, and any special garments which
are required in your job.
10. Don’t allow anyone who is not grounded closer than 1 meter to your static
safe area.
22 N1000A Quick Start Guide
To Next Page
Loading...
