4 Instrument Markings and Regu-
latory Information
The table below lists the definitions of markings that may be on or with the
product.
N1000A DCA-X Instrument Markings
The table below lists the definitions of markings that may be on the instrument.
Marking Description
The instruction documentation symbol. The product is marked with this symbol when it is necessary
for the user to refer to the instruction in the documentation
The ON/STANDBY symbol. The ON, OFF and STANDBY symbols are used to mark the positions of the
instrument power line switch.
The AC symbol is used to indicate the required nature of the line module input power.
The chassis ground symbol. The chassis ground symbol is used to indicate a chassis connection.
The CE marking is a registered trademark of the European Community (if accompanied by a year, it is
the year when the design was proven). It indicates that the product complies with all relevant dir-
ectives.
The CSA mark is a registered trademark of the CSA International.
The RCM mark is a registered trademark of the Australian Communications and Media Authority.
ISM 1A This is a symbol of an Industrial Scientific and Medical Group 1 Class A product (CISPR 11, Clause 5)
ICES/NMB-001 This is a marking to indicate product compliance with the Canadian Interference-Causing Equipment
Table 4. Instrument Markings
40
N1000A Quick Start Guide
To Next Page
Loading...
