2 Installing the N1000A
Step 7. Turn On the Instrument
Before switching on this instrument, make sure the supply voltage is in the
specified range. Refer to Table 3 on page 24.
1. Press the ON/Standby switch.
Figure 11. Location of ON/Standby Button
2. Wait while the instrument boots up. During the process, you will be asked to
accept the Windows 10 End User License Agreement (EULA). Once accep-
ted the N1000A will continue to configure itself.
3. After the instrument boots up, the FlexDCA oscilloscope application
appears and looks similar to the following figure.
28 N1000A Quick Start Guide
To Next Page
Loading...
