6 M8100 Series Arbitrary Waveform Generators Getting Started Guide
About This Guide
This guide provides high-level information for an initial setup of the M8100 Series
Arbitrary Waveform Generators. This guide focuses on setting up “bundled” systems such
as the M8100A-BU5 and M8100A-BU6.
The M8100A-BU5 system has one or more modules from the M8100 series and
pre-configured system consisting of one M9505A 5-slot AXIe Chassis with USB option.
The M8100A-BU6 system has one or more modules from the M8100 series and
pre-configured system (pre installed M9537A with M8070B and M8199A module driver)
consisting of one M9505A 5-slot AXIe chassis with USB option and one M9537A AXIe
Embedded PC Controller.
If you ordered a system that requires on-site installation of individual M8100 series
modules or the M9537A AXIe Embedded Host Computer into the M9505A AXIe Chassis,
refer to the M8000 Series of BER Test Solutions Installation Guide for detailed
module-level installation instructions.
For information on remote programming of one or more AWG modules in the M8100
series, refer to the M8100 Series Programming Guide.
To Next Page
Loading...
Need help?
General
